Chroma -Q Color Block 2 User Manual page 12

Mode Group Ch
1
Variable 67
2
Cell 60
3
Cell 60
4
Block 21
5
Block 15
6 Block 15
7 All 9
8 All 3
9 All 3
10 Cell 80
11 Cell 80
12 Block 20
13 Block 20
14 All 4
15 All 4
16 Any 1
When DMX is Lost
If DMX is not detected various output options can be selected: Press Enter, scroll
wheel to selection, press Enter for 2 seconds to save settings.
Off - will snap to off
Hold - will hold the last valid DMX state
Trig - will default to Time Trigger operation
Look 1-31 will snap to the Look of your choice
Look Store
The PSU-05B/PSU-30 has 31 internal preset FX Looks for stand alone operation, 1-23
are pre-programmed. To replay a Look in stand alone operation, scroll to Look Store,
press Enter, scroll and select the desired Look and press Enter for 2 seconds to save
settings. To replay a Look with a DMX console, scroll to Control Mode 16 and press
Enter for 2 seconds. Use the DMX console with the assigned channel to playback the
various looks stored. (1-31 looks in 1 single channel)
Note: DMX has priority over internal Looks.
Looks can be recorded to the internal flash memory by users and will be preserved
on power down. However, looks will be returned to default setting if menu 8 Reset is
performed. There are two ways to record a look:
Simple, with DMX console.
Set the PSU-05B/PSU-30 to the desired Control Mode. Use a DMX console to adjust
channel levels and create the desired look or effect. Scroll to Look Store and press
Enter, scroll to desired Look number and press Enter. Press Enter again for 2
seconds to save Look.
Advanced, stand alone. (DMX is unplugged)
Scroll to Look Store and press Enter, scroll to desired Look and press Enter to access
the memory data. The data is presented as two numbers separated by a letter "c".
The number to the left of the c is the channel number and to the right is the channel
level. Scrolling to the far end of the wheel will show the Mode at which the selected
Look was programmed.
To edit the Mode of a selected Look:
Scroll to Look Store and press Enter, scroll to desired Look and press Enter to access
the memory data. Scroll the wheel to the far end until Mode number is shown and
press Enter. Scroll wheel to adjust the Mode number. Press Enter to toggle back to
the channel numbers.
Color Block 2 User Manual
PSU-05B
System: CB2
7FX + 20 x HSI
20 x HSI
20 x RGB (with *Magic Amber)
6FX + 5 x HSI
5 x HSI
5 x RGB (with *Magic Amber)
6FX + HSI
1 x HSI
1 x RGB (with *Magic Amber)
20 x RGBA
20 x RGBI (with *Magic Amber)
5 x RGBA
5 x RGBI (with *Magic Amber)
RGBA
RGBI (with *Magic Amber)
Look Select
11
PSU-30
Ch
System: CB2
367 7FX + 120 x HSI
360 120 x HSI
360 120 x RGB (with *Magic Amber)
96 6FX + 30 x HSI
90 30 x HSI
90 30 x RGB (with *Magic Amber)
9 6FX + HSI
3 HSI
3 RGB (with *Magic Amber)
480 120 x RGBA
480 120 x RGBI (with *Magic Amber)
120 30 x RGBA
120 30 x RGBI (with *Magic Amber)
4 RGBA
4 RGBI (with *Magic Amber)
1 Look Select
V1.0 April 2009