Canon imageRUNNER 1750i Facsimile Manual page 57

• The pause time differs in length, depending on whether it is entered in the middle or at
the end of a fax number.
- The pause time entered in the middle of a fax number (lower-case p) is set to four
- The pause time entered at the end of a fax number (upper-case P) is set to 10
• Two or more pauses can be entered consecutively.
• You can press
4
2
● If you want to check or change the specified destination:
❑
● If you want to delete the specified destination:
❑
NOTE
If Confirm Entered Fax Numbers in Restrict the Send Function is set to 'On', you
should enter the fax number again for confirmation. Enter the fax number you entered
in step 3 ➞ press [OK]. (See Chapter 4, "Setting the Send Function," in the System
Settings Guide.)
2-30
Basic Sending Methods
seconds long by default. This can be changed to any length between 1 and 15
seconds. (See "Adjusting the Pause Time," on p. 7-24.)
seconds long. (This length cannot be changed.)
(Clear) to clear your entry.
Press [Details] ➞ check or change the destination's information ➞ press [OK].
For help, see step 4 in "Sending an E-Mail Message," on p. 2-2.
Press [Erase].
For help, see step 4 in "Sending an E-Mail Message," on p. 2-2.
Press [Direct] ➞ [OK].
The Direct Sending mode is set and the
specified destination appears on the top
screen.
You can also set to the Direct Sending
mode on the Send Settings screen. On the
top screen, press [Send Settings] ➞
[Direct] ➞ [Done].
To cancel the Direct Sending mode, press
[Direct] again.