Canon imageRUNNER 1750i Facsimile Manual page 283

# 0407
Cause 1
Remedy
Cause 2
Remedy 1 The full path must not be longer than 120 characters. Change or shorten the file
Remedy 2 Change the folder to which the data is saved.
# 0408
Cause 1
Remedy
Cause 2
Remedy
9
# 0703
Cause
Remedy 1 Wait for a few moments and try again after other send jobs are complete.
Remedy 2 Delete documents stored in memory. If the machine still does not operate
# 0705
Cause
Remedy 1 Change the setting for <Maximum TX Data Size> in E-mail/I-Fax Settings. (See
9-14
Self-diagnostic Display
The length of the full path to the specified file (or folder) exceeded the
supported limit.
The full path must not be longer than 120 characters. Change or shorten the file
name.
The transmission to the USB memory media device was not properly performed
because the length of the full path including the root and file name exceeded the
limit.
name.
The transfer of data has failed because the USB memory media device was
pulled out during the transfer.
Check that the USB memory media device is properly inserted, and then try the
transfer again.
An error occurred while data, such as image data, was being transferred to the
USB memory media device.
Check the status of the USB memory media device, or make sure that the
device is formatted with a file system supported by the machine (FAT16 or
FAT32), and then try again.
The memory for image data is full when sending color documents.
normally, turn the main power OFF and then back ON.
The send operation was interrupted because the size of the image data is larger
than that specified in <Maximum TX Data Size> in E-mail/I-Fax Settings.
Chapter 4, "Setting the Send Function," in the System Settings Guide.)