Canon imageRUNNER 1750i Facsimile Manual page 37

7
2
The settings listed below can be specified to suit your needs. Documents can be sent
to the specified destination regardless of whether any of these settings specified.
[Document Name]: Sets the name of the document that you want to send. You can
[Subject]:
[Message]:
[Reply-to]:
NOTE
• [Delayed Send] also can be specified as necessary. For more information, see
"Specifying the Time to Start Sending (Delayed Send)," on p. 2-44.
• When you are sending documents, each page is sent as a separate TIFF image
attached to the I-fax. The file name prefix of the image attached to the I-fax is
generated based on the date and time (year, month, day, hour, minute, second) and
four digits that signify the page number of the image.
Example: date and time_0001.tif
If you specify the Document Name setting in this step or set <Add user name to Send
Document Name> in User ID Management to 'On', the file name prefix is assigned as
follows:
- If you specify the Document Name setting:
2-10
Basic Sending Methods
enter up to 24 characters for the document name.
Sets the subject of the I-fax documents. You can enter up to 40
characters for the subject.
If you do not enter a subject, the default subject set in <Default
Subject> is used. (See Chapter 4, "Setting the Send Function," in
the System Settings Guide.)
Sets the message body text. You can enter up to 140 characters
for the message. A hard return is counted as one character.
Sets the reply-to address. When you press [Reply-to], e-mail
addresses stored in the Address Book appear. Select one
address from the Address Book as the reply-to address. For
instructions on how to use the Address Book, see "Using the
Address Book," on p. 4-24.
E-mail addresses must be stored in the Address Book
beforehand. (See "Registering the Address Book," on p. 4-3.)
The document name specified in Document Name comes first as the file name
prefix.
Example: document name_date and time_0001.tif
Specify the send settings you
require ➞ press [Done].
Press [ ] or [ ] to scroll to the desired
setting if it is not displayed.