Light Control - Ducati Multistrada 2200S Pikes Peak Owner's Manual

Light control

Headlight control
This function allows you to reduce current
consumption from the battery by automatically
managing headlight switching-off.
At Key-On, the high beam and low beam lights are
off. When the engine is started, the low beam lights
turn on automatically; from this moment, "normal"
operation is activated: it will be possible to switch to
high beam - i.e. high beam light will turn on together
with low beam light using button (3) - or operate the
"FLASH" signal (using button 3). If engine is not
started upon key-on, it is anyway possible to switch
the lights on by pushing the button on the LH high/
low beam switch (button 3).
The low beam lights are turned on the first time it is
pressed; from this moment, the same button can be
used to switch on (and off) the high beam light (if the
engine is not started within 60 seconds, the low
beam or high beam light that was turned on will turn
off).
146
If the headlight was turned on before starting the
engine with the procedure described above, the
headlight turns off automatically when starting the
vehicle and will turn on again when the engine has
been completely started.
3
Fig 80