Ducati Multistrada 2200S Pikes Peak Owner's Manual page 158

"SPEED" setting
The arrows indicate the current setting, with buttons
(1 and 2) it is possible to select the new setting.
To store the new setting it is necessary to press the
reset button (4) for 3 seconds.
After the setting is stored, system quits the page and
rider should do a Key-Off; upon next Key-on any new
unit of measurement will be set.
1) Km/h: by setting this condition the following values
will have the same units of measurement:
- TOT, TRIP1, TRIP2, RANGE: Km
- Vehicle average speed: Km/h
2) mph : by setting this condition the following values
will have the same units of measurement:
- TOT, TRIP1, TRIP2, RANGE: miles
- Vehicle average speed: mph
"TEMP." setting
The arrows indicate the current setting, with buttons
(1 and 2) it is possible to select the new setting.
To store the new setting it is necessary to press the
reset button (4) for 3 seconds.
After the setting is stored, system quits the page and
rider should do a Key-Off; upon next Key-on any new
unit of measurement will be set.
3) °C: by setting this condition the following values
will have the same units of measurement:
- Engine coolant temperature and T_AIR: °C
4) °F: by setting this condition the following values
will have the same units of measurement:
- Engine coolant temperature and T_AIR: °F
"CONS." setting
The arrows indicate the current setting, with buttons
(1 and 2) it is possible to select the new setting.
To store the new setting it is necessary to press the
reset button (4) for 3 seconds.
After the setting is stored, system quits the page and
rider should do a Key-Off; upon next Key-on any new
unit of measurement will be set.
5) Km/L: by setting this condition the following values
will have the same units of measurement:
- CONS. and CONS. AVG: Km/L
155