Table of Contents
Advertisement
Light control
Low / High beam
By means of button (A) it is possible to switch from
low beam to high beam and vice versa: position (B)
for high beam, position (C) for low beam. To flash,
press the button (D).
If engine is not started after turning the key to on, it
is nevertheless possible to switch on the lights or
flash.
If within 60 seconds from the manual switching on of
the low or high beam the engine is not started, the
lights are turned off.
To preserve the motorcycle battery, the headlight is
automatically switched off when starting the engine
and it is then switched on again when the engine has
started.
DRL in "Auto" mode – only for version with
DRL lights
If the DRL lights were set to "Auto" via the "DRL"
function within the "SETTING MENU" (see page
155), the instrument panel automatically manages
the DRL and the low beam according to detected
ambient light:
B
A
C
G
H
F
D
Fig 32
E
I
Fig 33
67
Advertisement
Table of Contents
