Microscan MS-3 Quick Start Manual page 11

Step 9 —Save Calibration Settings
After calibrating the MS-3, you can save your new settings to be
available at power-on.
By ESP
Caution: If you have settings in the scanner that you have not yet
loaded into ESP, the ESP settings will overwrite the scanner's settings
when you save. Under these conditions, it is highly recommended
that you first select
power-on.
After testing and/or calibrating the scanner, you
can save the settings for power-on by clicking the
Save button.
By EZ Button
Press and hold the
until you hear three beeps and
see three performance LEDs
momentarily turn amber.
1. This assumes that the default functions of the test button have not been re-programmed.
MS-3 Laser Scanner Quick Start Guide
Receive Reader Settings
Test button
1
EZ Button
Read rate
performance
LEDs
Save Settings
before you save for
TEST
100% GR
ST
80%
60%
40%
20%
PWR
11-000063-01
11