Power Nozzle Height Adjustment/Techdrive ® Power Assist - Kirby G Series Owner's Manual

Getting Started
Getting Started
Power Nozzle Height Adjustment and TechDrive ® Power Assist
IMPORTANT:
!
8 T h e K i r b y C o m p a n y
Then, each time you press on the Toe-Touch Control ™ Upper
o
Pedal , you will lower the front one notch.
8
The number of bars showing above the Toe-Touch Control
provide an indication of height. ❏
POWER NOZZLE HEIGHT ADJUSTMENT
When using the Power Nozzle
the height properly. Start by pressing the Toe-Touch Control
o
Bottom Pedal
9
Ultimate G all the way up.
Then, with your Ultimate G ON, press the Toe-Touch Control
o
Upper Pedal , one notch at a time, until you hear a change in
8
the tone of the motor. This means your Ultimate G has sealed to
the carpet. Press the Toe-Touch Control Upper Pedal one more
time and your Power Nozzle will be at the proper operating height.
NOTE: When finished vacuuming, press the Toe-Touch Control
Bottom Pedal all the way down to move your Ultimate G. ❏
TECHDRIVE
Your new Ultimate G is equipped with TechDrive Power
Assist. This innovative power assist feature eliminates most of
the effort required to move your Ultimate G back and forth. ❏
TURNING TECHDRIVE ON (DRIVE)
To engage TechDrive and put the Ultimate G in the Power
Assist mode, push down the yellow "D" side (marked "D" for
Drive) of the TechDrive N/D Pedal
o
Power Switch.
1 3
You may use your Ultimate G without TechDrive Power Assist
if desired. Simply put TechDrive in Neutral. ❏
TURNING TECHDRIVE OFF (NEUTRAL)
To move your Ultimate G with the motor OFF or to vacuum
without Power Assist, TechDrive must be put in Neutral.
To place TechDrive in Neutral, push down the gray "N" side
(marked "N" for Neutral) of the TechDrive Power Assist N/D
o
Pedal . ❏
11
To avoid possible damage to soft tiles or marking of waxed and
finished non-carpeted floors, disengage the TechDrive.
o
, it is important to adjust
2 5
all the way down, raising the front of your
o
12
located just below the