Kirby G Series Owner's Manual page 32

for those who apprecia te quality, reliability & performance
Optional Accessories
Optional Accessories
CARPET SHAMPOO SYSTEM SET-UP (cont)
5
While sliding the Carpet Shampoo System Nozzle/
Tray Assembly toward the Ultimate G and over the
o
Motor Shaft
2 3
of the nozzle to the Attaching Bar
Push the nozzle up against the Ultimate G and turn the
6
Accessory Lock
nozzle in place. To engage the belt, use the L-shaped
handle on the Belt Lifter to turn it all the way to the
right (clockwise) until the green arrows line up. Then lower
the Headlight Hood
The Shampoo Tank is removable and should be filled or
emptied at your sink.
NOTE: The Shampoo Tank is removed and re-attached in the
same way as the Mini Em-Tor ® (see page 10 for details).
7
Unscrew the large cup from the top of the Shampoo
Tank and turn the Suds Control Valve fully to the left
(counter-clockwise) to OFF.
Holding the Shampoo Tank level, fill it to the full line with
warm water (not hot).
Using the large cup from the top of the tank, pour three cup-
fuls of Kirby ® Carpet Shampoo into the Shampoo Tank. Do
not use more, as over-foaming will result.
NOTE: One tankful of solution will clean about a 10x12 foot
carpet (3x3.5m). Larger carpets will require refilling the
Shampoo Tank.
Replace the large cup into the opening on top of the
Shampoo Tank. ➤
The Carpet Shampoo System
, connect the hooks on the bottom rear
o
. ➤
2 4
o
to the right (clockwise) to lock the
22
o
. ➤
2 1
31