Kirby G Series Owner's Manual page 37

Optional Accessories
Optional Accessories
The Carpet Shampoo System (continued)/The Floor Care
System-Miracle Waxer ®
KIRBY MIRACLE WAX DIRECTIONS
For Hardwood, Vinyl, Cork and Linoleum Floors:
1. Clean surface thoroughly.
2. A ttach Kirby Floor Care System Buffer Nozzle and
Brush according to the instructions on page 38,
u nder ''Floor Buffer Set-Up."
3. For best results, apply a very thin coat of Kirby
Miracle Wax using the roller applicator. It is not
necessary to completely cover the floor with wax at
this time, as the wax will be spread in the next step.
4. Using the Toe-Touch Control ™ Upper Pedal to
lower the nozzle all the way down, spread the
wax evenly
using the Kirby Floor Care
Buffer Brush.
5. Let dry 5 minutes.
6. When dry, buff with the Kirby Floor Care System
B uffer Brush.
36 T h e K i r b y C o m p a n y
REPLACING A WORN CARPET SHAMPOO
SYSTEM NOZZLE BELT (cont)
3
Align the metal ends of the brush with the slots on the
tray and push the brush in until it snaps into place. The
brush will only fit the tray the correct way.
NOTE: The belt should not be stretched when stored for an
extended period. Make sure the green arrows line up for
storage (see page 10 for discussion of the Belt Lifter). ❏
USING THE KIRBY ® MIRACLE WAXER
1
To assemble the roller waxer applicator, attach the top
half of the roller waxer handle to the bottom half (if not
already done). Adjust the upper half until the spring-
loaded pin in the lower half is seated in the hole near the bot-
tom of the upper half. ➤
2
With the wax roller bag facing the hooked end of the
long roller handle, push the wax roller over the connector
on the bottom of the handle until secure. ➤
NOTE: For very worn areas, two coats may be
For Marble Floors:
Once you have completed the steps above, the floor
may be rebuffed, any time it becomes necessary, using
the Floor Care System Buffer Brush. Apply additional
wax ONLY when rebuffing does not produce
acceptable results.
over the entire floor
System
IMPORTANT:
re quired. In this case, multiple thin coats will
provide better results than one thick coat.
Apply a thin coat and spread as in the directions in
#4. However, buff immediately, avoiding any
drying time.
Do not use Kirby Miracle Wax on rubber
or asphalt tile. ❏