Kirby G Series Owner's Manual page 48

for those who apprecia te quality, reliability & performance
Operating/Maintenance Tips
Operating/Maintenance Tips
CHANGING THE POWER NOZZLE BELT (cont)
5
Make sure the Brush Roll Bristle Height Adjustment
setting (1, 2, or 3) is the same as when the brush was
removed. See page 48 for discussion of the Brush Roll
Bristle Height Adjustment (1, 2, or 3). Place the belt
and Brush Roll back into the nozzle. One of the plastic Brush
Roll ends is larger than the other, thus the Brush Roll will
only fit in the nozzle one way.
Then center the belt on the Brush. ➤
6
Replace the Rug Plate
the bumper first and then pulling it over the bumper on
rear of Power Nozzle
the two latches that hold it in place. ➤
7
Using the L-shaped handle on the Belt Lifter
to the left (counter-clockwise) until the red arrows line
up. This will stretch the belt in preparation for return-
ing the nozzle to the Ultimate G.
Now you are ready to re-attach the Power Nozzle and
re-engage the belt (see page 11 for details). ❏
Changing The Power Nozzle Belt
o
by placing it on the front of
2 6
o
. Secure the Rug Plate using
25
o
, turn it
2 0
47