Kirby G Series Owner's Manual page 41

Optional Accessories
Optional Accessories
The Floor Care System-Floor Buffer (continued)/The Floor Care
System-Carpet Fluffer
40 T h e K i r b y C o m p a n y
USING THE FLOOR BUFFER (cont)
9
Press the Toe-Touch Control ™ Upper Pedal
the brush one notch at a time. Lower the brush as far as
the Toe-Touch Control will allow.
With the Buffer running, move the Ultimate G over the floor
as though you were cleaning a carpet, using slow, steady
strokes.
NOTE: The belt should not be stretched when stored for an
extended period. Make sure the green arrows line up for stor-
age (see page 10 for discussion of the Belt Lifter). ❏
HARD FLOOR PAD
See page 15 for set-up and use of the Hard Floor Pad. ❏
USING THE CARPET FLUFFER
Your Kirby ® Floor Buffer can also be used as a Carpet
Fluffer to reset the nap on a matted-down carpet.
1
Before fluffing the carpet, raise the nozzle all the way
up by pushing the Toe-Touch Control Bottom Pedal
all the way down.
Place the cleaner on the carpet to be fluffed. ➤
2
Plug in the Power Cord. Disengage the TechDrive ®
Power Assist by pressing on the gray "N" side of the
TechDrive Power Assist N/D Pedal
Holding onto the handle firmly, start the cleaner by pressing
the ON switch. ➤
o
to lower
8
o
9
o
.
1 1