Kirby G Series Owner's Manual page 23

Canister Cleaner & Attachments
Canister Cleaner & Attachments
Using your Ultimate G as a Blower (continued)
22 T h e K i r b y C o m p a n y
BLOWER SET-UP (cont)
2
Raise the Headlight Hood
handle on the Belt Lifter
Lifter all the way to the left (counter-clockwise) until
the red arrows line up. ➤
3
Unlock the Power Nozzle
o
Lock all the way to the left (counter-clockwise). The
2 2
Power Nozzle should tip forward when it is released.
Lift nozzle away from the Ultimate G and off. ➤
4
When using the blower attachments, the Air Intake
Guard must be attached to the front of the Ultimate G.
Fasten the Air Intake Guard onto the Attaching Bar
the same way you would the Attachment Hose. Then lock it
on by turning the Accessory Lock
(clockwise). ➤
5
To remove the entire Bag Assembly, grasp the Mini
o
Em-Tor ®
in the hand-hold provided and rotate it out
6
and away from the Ultimate G as far as it will go. Then
lift it off.
(To replace the Bag Assembly after use as a blower, see page 10.)
Release the Outer Permanent Bag Top from the Bag Support
o
by pressing the Bag Release Button
1 6
bag top down. (See page 15 for details.) ➤
o
and flip out the L-shaped
2 1
o
. Use it to turn the Belt
2 0
o
by turning the Accessory
25
o
all the way to the right
2 2
o
and sliding the
16
o
2 4