Installing/Changing Disposable Filter Bags - Kirby G Series Owner's Manual

CAUTION:
!
for those who apprecia te quality, reliability & performance

Installing/Changing Disposable Filter Bags

INSTALLING/CHANGING DISPOSABLE
FILTER BAGS
A Disposable Filter Bag must be installed before you begin
vacuuming.
1
To install a new Disposable Filter Bag, unzip the Outer
Permanent Bag
along with the Top Adaptor
2
When necessary, remove the used Disposable Filter Bag.
NOTE: Always replace the Disposable Filter Bag when
dirt reaches the "FULL" line on the bag. Failure to do
so will affect performance.
From the rear of the Disposable Bag, grasp the cardboard face-
plate. Holding the Top Adaptor steady, rotate the cardboard
faceplate to the left (counter-clockwise). When the lock tabs
on the Top Adaptor align with the slots in the cardboard face-
plate, gently pull the bag off. ➤
3
To install a new Disposable Filter Bag, grasp the card-
board faceplate from the rear of the Disposable Filter
bag. Align the slots in the cardboard faceplate on the
Disposable Filter Bag with the lock tabs on the Top
Adaptor. Then push the Top Adaptor into the bag opening.
Holding the Top Adaptor steady, rotate the cardboard faceplate
to the right (clockwise) to secure the Disposable Filter Bag.
NOTE: To avoid air leaks, make sure the cardboard faceplate is
securely positioned up against the flat portion of the Top
Adaptor. ➤
Before changing the Disposable Filter Bag, unplug the power cord
from the wall outlet and be sure that the motor and fan have stopped.
Getting Started
Getting Started
o
and pull out the Disposable Filter Bag
1
o
. ➤
5
9