Changing The Power Nozzle Belt - Kirby G Series Owner's Manual

Operating/Maintenance Tips
Operating/Maintenance Tips

Changing The Power Nozzle Belt

46 T h e K i r b y C o m p a n y
CHANGING THE POWER NOZZLE BELT
After extended use, the Power Nozzle Belt on your Ultimate G
may become stretched and worn causing the belt to slip.(See
page 11 - Brush Roll Performance Indicator Light.) If this
condition exists, simply replace the old belt with a new one.
1
NOTE: Use only approved Kirby ® belts.
To change the belt, remove the nozzle from the
Ultimate G as on page 18. Then release the belt tension
by using the L-shaped handle on the Belt Lifter
all the way to the right (clockwise) until the green arrows
line up. ➤
2
Unlock the Rug Plate
on the rear of the nozzle. ➤
3
Pull on the rear edge of the Rug Plate to remove from
the nozzle.
Note the Brush Roll Bristle Height Adjustment setting
(1, 2, or 3).
Lift out the Belt and Brush Roll. ➤
4
Slide off the old belt and replace with a new one. ➤
o
2 0
o
by unhooking the two latches
2 6
to turn it