Memory Cards; Insertion And Removal - CAB a2+ Configuration Instructions

A2+/A4+/A6+/A8+

Memory cards

8 Memory cards
You can save graphics, fonts, label descriptions and database information for the long-term on a memory
card.
Always create a backup copy of the memory card in case of a malfunction.
You can use the following memory card types:
•
Type 1 CompactFlash card up to a maximum size of 1 GB in the corresponding card slot of the printer
or in the external operating panel (cab accessory)
•
PC card (PCMCIA) in the corresponding card slot of the printer
8.1

Insertion and removal

Fig. 23: Inserting memory card
When the memory card is slid onto the contact pins, light physical resistance can be felt.
1. Slide memory card contact-side first into the slot as far as it will go.
The rear section of the inserted memory card still extends from the device housing so that it can be
removed by hand.
2. Press the menu button.
3. Check whether the Memory card menu is shown in the display.
If the Memory card menu is not shown in the display, it could be because:
•
you have not selected the card slot being used as the primary card slot
•
you have not inserted the memory card far enough into the card slot
•
you have entered the memory card incorrectly
Do not remove the memory card while it is being accessed. You can configure the printer so that access
to a memory card is indicated on the status line (see "4.1.5" on Page 26).
58 Configuration Instructions Edition 5/06