Section 3.8 Anti-Pass Back; Programming The Anti-Pass Back Mode; Re-Sync All Devices; Re-Sync Individual Devices - DKS 1837 Series Installation & Owner's Manual

3.8 Anti-Pass Back
The programming steps below will allow you to set up and program some basic functions for the anti-pass back feature (APB).
However, you must set up the IN and OUT relay programming table in the Remote Account Manager software. Anti-Pass
Back tables cannot be set from the system keypad. Refer to "Remote account manager for windows" manual 1835-066.

3.8.1 Programming the Anti-Pass Back Mode

Anti-Pass Back (APB) can be set to operate in one of three different modes. PASSIVE APB records an APB Violation and will
allow entry or exit. ACTIVE APB records an APB Violation and will not allow entry or exit. TRAP APB records an APB Violation
and will allow entry but not exit.
GHI GHI DEF DEF
1. Press
4 4 3 3
OPER OPER
2. Enter for OFF,
0 0
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0

3.8.2 Re-Sync All Devices

This programming step is used to allow all cards one 'move' either in or out without causing an APB Violation to be recorded.
GHI GHI JKL JKL
1. Press
4 4 5 5
OPER OPER
2. Press to Re-Sync ALL devices or press
1 1
3. The programming sequence will end itself after all cards have been re-synced.

3.8.3 Re-Sync Individual Devices

This programming step is used to re-sync a single card only.
GHI GHI MNO MNO
1. Press
4 4 6 6
2. Enter the five-digit device number, then press
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0

3.8.4 Reset Facility Counter

This programming step is used to reset the facility counter. The facility counter keeps track of the number of "IN's" and
"OUT's" when using APB mode.
GHI GHI TUV TUV
1. Press
4 4 8 8
2. Enter a five-digit number that you want the count to start at, then press
Example: to start the count at 25, enter 00025.
OPER OPER
3. Press together to end this programming sequence (beeeeeep).
0 0
1835-065-J-7-14
and enter your four-digit MASTER CODE
OPER OPER ABC ABC
for PASSIVE, for ACTIVE or
1 1 2 2
and enter your four-digit MASTER CODE
OPER OPER
0 0
and enter your four-digit MASTER CODE
and enter your four-digit MASTER CODE
? ? ? ? ? ?
DEF DEF
for TRAP, then press
3 3
? ? ? ? ? ?
to NOT Re-Sync, then press
? ? ? ? ? ?
(beep).
? ? ? ? ? ?
? ?
(beep).
(beep).
? ?
(beep).
(beeeeeep).
? ?
(beep).
? ?
(beep).
(beep).
45