Yowza Captiva Elliptical User Manual page 15

STEP2 ASSEMBLY
STEP2-A
705
STEP2-A). Remove the Undercarriage Cover (704, 705) by carefully lifting pedal
Assembly and removing each piece one at a time. Be careful not to snap
Plastic push pins when taking apart. Place Styrofoam block (8) under
Main Frame tube to provide clearance for positioning of Main Frame (112) for
Assembly. Verify that rear incline frame holder (206) is securely tightened
to Main Frame (112).
STEP2-B). Attach Incline Frame Set to the Main Frame, and hold the Incline Frame
Holder – Front (708) to the Incline Frame (109), secure using Allen head
CAP Bolts (511) with Spring Washer (517) on the Incline Frame Holder.
Don't fully tighten Allen Head CAP Bolt (511) until STEP2-D
STEP2-C). Rotate the Incline Frame (109) to align the bolt holes with the mating bolt
Holes in the Incline Transmission Tube-Front (110).
Assemble the Incline Transmission Tube-Front (110) to the Incline Frame
(109).
STEP2-D1). Firstly, tighten the Allen Head Bolt (507), and make sure again that
already fully was matched here.
STEP2-D2). Then fasten the Nylon Nut (508) by 8mm Allen Key (C) and Wrench (D).
Fully tighten the Allen Head Bolt (50) by 8mm Allen Key.
704
112
8
112
STEP2-B
511
507
http://www.yowzafitness.com/
STEP2-C
D
507 508
109
708
STEP2-D
C
109
508
708
517
511
511 X4
517 X4
507 X1
508 X1
15
F
109
109
708
511