66
4.
Lower and raise the arms while running the engine at idle
speed and again while running the engine at 1500 rpm.
Note:The arms should slow when they are at approximately
?
18 inches (45.72 cm) away from the arm stops and
gently come to rest against the arm stops.
5.
If the arms reach the stops with jarring impact or the arms
stop before reaching the arm stops:
a
Loosen one retaining bolt and tap the cam in the
required direction.
b
Tighten the retaining bolt of the cam and repeat step
4.
6.
Attach a container to the forks and repeat step 4 and step
5.
7.
Remove the container from the forks and repeat step 5
and step 6 until the arms decelerate with and without a
container on the forks.
8.
Tighten the locking setscrew.
Part #: 90309