62
E
LEMENT
1.
Complete the lockout/tagout procedure.
?
Note: Keep tools, working area and equipment clean. A pan
will be required to collect a small amount of oil lost as
the element is removed.
The filter housing is fitted with a check valve,
therefore it is not necessary to drain the hydraulic
tank.
2.
Loosen the 4 cover plate bolts using a ½-inch wrench,
rotate through 45° and lift off.
3.
Use an oil tray to pick up oil.
4.
Carefully remove the element, rotating it as you do so to
release suction.
5.
Inspect O-rings (on filter and on cover plate) and housing
for damage. Replace as necessary.
6.
Moisten sealing surfaces (with oil) on the filter housing
and cover plate.
Oil tray
7.
Install element into housing, carefully locating the element
onto the spigot.
8.
Replace cover plate.
9.
Operate hydraulic system and check for leaks.
Seal on
cover plate
R
EPLACEMENT
P
ROCEDURE
Part #: 90309