HAMPTON BAY HI300 Owners & Installation Manual page 21

9) Remove the wires one at a time from the existing
switch plate, and attach each wire to the new switch
plate, each wire in the same position as it was on
the old switch plate (see wiring diagram). Discard
the old switch plate.
10) Attach the thermodisc assembly to the mounting
holes located on the right side of the base of the
main fan body using the existing hardware - 2 bolts,
nuts and washers.
Important Note:
On older fan units these holes may require drilling.
Use template provided to drill holes. Place template
by aligning to the right corner of the thermodisc as-
sembly base. See Diagram 1.
Thermodisc Assembly
Template (If required)
Location of New
Thermdisc Holes
Thermodisc As-
sembly Base
Diagram 1
918-378
Hampton HI300 Wood Cast Insert
POWER OUTLET CONVERSION
Switch
Plate
Location of Old
Thermdisc Holes
11) Attach the new cover plate to the left side casting us-
ing 2x #6 32x3/8" Pan Head Phillips black screws.
12) Attach the fan defl ector to the main fan body by
replacing the Phillips screw on the top of the fan
housing.
INSTALLATION
HI300
Left Cover Plate
21
07/23/08