Table of Contents
Advertisement
Full Installation and Setup
The Easy Install feature can also be used when one person installs and sets up the
FrameSaver unit from beginning to end.
Procedure
1. Follow Step 1 through Step 8 of
2. If the unit will be enforcing CIR (Committed Information Rate) and EIR (Excess
Information Rate) on network frame relay links, enable Traffic Policing.
Main Menu
You can change other Frame Relay and LMI default settings, if necessary.
3. Configure each interface according to the local management interface (LMI) and
assigned line conditions supplied by the service provider.
Configuration
Configuration
4. Install the network cable (see
FrameSaver unit starts discovering DLCIs (see
page 17).
5. If SNMP traps are wanted, set up managers and select the desired traps (see
Configuring SNMP Trap Managers and Traps
6. Verify the entire path from the FrameSaver unit to the NOC NMS is functioning (see
Verifying the End-to-End Path
7. If the Ethernet port will be used for management, install the Ethernet cable (see
Connecting the LAN Cable
8. Install the DTE cable (see
9. Verify that data is being received (see
page 22).
10. Verify that all PVCs, including Management PVCs, are configured (see
PVC Connections
The FrameSaver installation is complete.
See the
FrameSaver SLV Operations Guide (9000-A2-GB33)
troubleshooting information.
Minimal Installation
Configuration
Network
Network
Frame Relay
T3 User Ports
Connecting to the Network
on page 19.
on page 20).
Connecting to the DTE
on page 22).
on page 14.
Frame Relay
Frame Relay
Automatic Configuration
on page 19).
on page 20).
Checking that Data is Being Received
16
on page 17). The
on
Checking
for additional status and
on
Advertisement
Table of Contents
