Connecting The Terminal Cable - Paradyne FrameServer SLV 9520-ILM Installation Instructions Manual

Connecting the Terminal Cable

The TERMINAL PORT on the back of the FrameSaver SLV 9520-ILM can be used to
connect a VT100-compatible terminal or a PC with terminal emulation software. The
port can be protected by access level or password. See the
Configuration Reference (9000-A2-GB31)
Connect a terminal or PC to the unit with an EIA-232-F straight-through cable.
Procedure
To install the cable with a terminal or PC:
1. Press the 25-pin connector of the cable onto the TERMINAL PORT socket on the
back of the FrameSaver SLV 9520-ILM. If the cable will be permanently attached,
fasten the connector and fix the cable to the rail with a cable tie or other strain relief
device.
2. Connect the other end of the cable to the serial port of your terminal or PC.
T E
L A
N
3. Verify that the terminal or emulation software is set to:
— 19200 bps
— 8 data bits
— No parity bit
— 1 stop bit
— No flow control
R M
P O I N
1
A L
R T
for more information.
3
2
4
5
8
FrameSaver SLV
PC or
Terminal
00-16776