Table of Contents
Advertisement
Connecting the LAN Cable
The LAN port can be connected to an Ethernet hub using a standard 10BaseT cable, or
to a Network Interface Card (NIC) in a PC using a crossover cable. The LAN port
provides a high-speed connection that can be used for FTP and Telnet sessions.
Procedure
To connect the FrameSaver SLV 9520-ILM to an Ethernet hub or NIC:
1. Select the correct cable:
— To connect the LAN port to a hub, use a standard 10BaseT cable
— To connect the LAN port to a NIC, use a 10BaseT crossover cable
2. Insert the 8-pin modular connector of the cable into the LAN socket on the back of
the FrameSaver SLV 9520-ILM. It locks in place when it is fully seated.
3. Fix the cable to the rail with a cable tie or other strain relief device.
4. Connect the other end of the cable to your LAN hub or NIC.
Ethernet
Connecting to the DTE
Procedure
1. Take the end of the receive cable and push it on to the CPE RX connector on the
back of the unit. Turn the cable connector clockwise to lock it.
2. Connect the other end of the receive cable to the transmit port of the CPE DTE.
T E
R M
I N
P O
A L
R T
L A
N
20
1
3
2
00-16777
Advertisement
Table of Contents
