Section 6: Switch Panel; Switch Panel Location; Switch Panel Mounting; Switch Panel Wiring - Aqua-Hot 375LP Installation Manual

S 6: S
ECTION WITCH

Switch Panel Location:

Select a location that allows for easy operator ac-
cess. The switch panel should be easily visible as it
incorporates a blinking fault indicator light (Diesel-
Burner switch only), which indicates a diesel-burner
malfunction.

Switch Panel Mounting:

1. Cut out a 2.5" W x 1.5" H opening for the switch panel
plate. Reference Figure 35.
Once the switch panel has been completely wired, per-
2.
manently mount the switch panel in place.
3. Move both switches to an OFF position by pressing
them in a downward motion.
Figure 35
P
ANEL
®
© 2010 Aqua-Hot 375-LP Installation Manual—Rev. A

Switch Panel Wiring:

1. Run 16-gauge wires from the switch panel to the termi-
nal access block.
NOTE: It is recommended that the wire numbers in Appendix
A be used when installing the Aqua-Hot in order to
aid service personnel with troubleshooting.
Strip and crimp insulated female terminals onto each
2.
wire at the switch panel location.
NOTE: Be sure to attach a jumper wire for the electric switch
from Pin 4 to Pin 1. Reference Figure 37.
3. Connect all switch wires to the appropriate switch con-
nections as illustrated in Figures 36 and 37. Reference
Appendix A for additional wiring information.
4. Insert all switch wires into the appropriate terminal/
switch panel connection on the terminal access block.
Reference Figure 37 and Appendix A.
— Page 30 —