Switch Panel - Aqua-Hot 400 Series Installation Manual

Mounting the Aqua-Hot LCD

Switch Panel

Interior Switch Panel
Select a location in the interior of the coach that allows for
easy operator access. The switch panel should be installed in
a central location inside the coach that is easily accessible to
turn the system on and off. Mounting plate dimensions for the
panel are shown below.
Coach Control Panel Screen:
Newer Aqua-Hot units that come equipped with the Reporter
may have a coach touch-screen display instead of the interior
switch panel. This section is only for the installation and wiring
for the interior switch panel.
All electrical installations, systems, and equipment shall
comply with Article 551, Parts I through VI of NFPA 70, as well
as the regulation of authorities having jurisdiction and CSA
Standard B139.
NOTE: Be sure to attach "Jumper Wires" where
necessary. Reference the following switch diagrams.
2.88" 2.33"
p. 28
5.00"
4.45"
©Aqua-Hot® 450D Installation Manual
Switch Panel Mounting
1. Cut out a 3.75" W x 1.25" H opening for the switch
panel plate. Reference Figure 50.
2. Once the switch panel has been completely wired,
permanently mount the switch panel in place.
3. Using four countersunk 3mm (#4) screws, secure the
switch plate into place over the cutout just made.
Switch Panel Wiring
1. Run 16-gauge wires from the switch panel to the
Reporter.
2. Strip and crimp insulated female terminals onto each
wire at the switch panel location.
3. Connect all switch wires to the appropriate switch
connections. Reference the following diagrams per the
switch model.
4. Insert all switch wires into the appropriate pin connection
for the Reporter. Reference the schematic on Page 49.
Ø 0.15"
Figure 50