Sleep Mode Activation/Deactivation; Hazard Signalling; Remote Control Batteries Replacement - Gemini 7853 User Manual

11.0 - SLEEP MODE ACTIVATION/DE-ACTIVATION
When the vehicle is not used, it is possible to switch completely off the alarm
(sleep mode) in order to reduce the battery charge consumption.
To activate this function, proceed as follows:
!
Turn the ignition key to "ON" position; the LED will light for about one
second.
!
After the LED flash put the electronic key into the receptable, within 4
seconds.
!
An acoustic signal will indicate that the system is turned off.
!
Turn the ignition key of the vehicle to "OFF" position.
!
To re-activate the alarm, turn the ignition key of the vehicle to "ON" and
"OFF".

12.0 - HAZARD SIGNALLING

The hazard signalling is useful when you want to park the vehicle, being the
vehicle engine off and the turn signals on.
To activate/deactivate this function, proceed as follows:
!
Switch off the engine, by turning the ignition key of the vehicle to "OFF".
!
Turn the ignition key to "ON"; the LED will be illuminated for about 1".
!
During this period, push the button Nr.1 of the remote control.
!
Turn the ignition key to "OFF"; the turn signals will start flashing.
!
To deactivate the function, you must just turn again the ignition key to "ON"
(and eventually to "OFF"), or arm and disarm the system by a remote or by
an electronic key.
PAG.16
13.0 -

REMOTE CONTROL BATTERIES REPLACEMENT

The remote control operates using alkaline batteries.
Under normal use conditions of the remote control these will gradually lose
their charge.
The more you use the remote control, the sooner the batteries will become
discharged.
To prevent problems with the remote control, it has been provided with a device
that will signal the charge condition of the batteries inside.
During normal use of the remote control, when you press a command button
the green transmission LED will light up with a steady light.
If the battery charge drops below the level needed to assure correct operation
of the remote control, when you press a command button the green
transmission LED will blink, advising you that it is time to replace the batteries.
For battery replacement follow the indications reported below:
!
Separate the plastic shells of the remote control, paying attention to not
damage the internal circuit.
!
Remove the discharged batteries.
!
Insert the new batteries in their housing, being careful to not invert the
polarity.
!
Close the plastic shells of the remote.
!
Verify the efficiency of the remote control.
BATTERIES
ATTENTION
!
Use only batteries CR1616 type.
Using batteries different from those advised can seriously damage the
remote control unit.
Do not discard used batteries in the environment; they should be disposed
in appropriate containers.
PAG.17