Example Of Pin-Code Personalization - Gemini 7853 User Manual

10.0 - EXAMPLE OF PIN-CODE PERSONALIZATION

To better understand how to set up the PIN-CODE, please refer to the example
below.
The following customized PIN-Code 2-3-4-1
Turn off the system.
Connect the BROWN/GREEN
wire to ground.
BROWN/GREEN
NEGATIVE
Turn the ignition key in "ON" position
Key in "ON" position
The LED installed on the vehicle will light up for 0.5 seconds.
During this time period, press both buttons on the remote control.
The alarm will emit two acoustic signals and then it will light the LED.
0.5
Sec.
Remove from negative the
BROWN/GREEN wire.
BROWN/GREEN
NEGATIVE
PAG.14
will be entered.
Open the saddle of the vehicle if the
safety button is fitted.
.
.
Boop Fixed
light
Boop
Close the saddle of the vehicle if the
safety button is fitted.
P ush both remote control buttons at the same time.
The LED will go off
Turn the ignition key in "OFF" position
After four seconds have passed, the LED will begin a series of nine flashes.
Turn the ignition key in "ON" when we intends to memorize the first
figure of the new PIN-CODE.
Key in "ON"
position.
Afte four seconds have passed, the LED will begin a new series of nine
flashes.
Repeat the operations described above to insert the second number.
Key in "ON"
position.
Repeat the same operations described above to insert the other two numbers.
When you have finished inserting the fourth number of the pin-code, the
system will automatically exit the procedure. It will confirm the successful
termination with two low tone acoustic signals and one high tone signal.
Key in
Last
"ON"
number.
position.
.
LED
off
.
Key in "OFF" position.
LED
Key in "OFF"
off
position.
LED
Key in "OFF"
off
position.
Key in
Boop
"OFF"
Boop
position.
PAG.15