Making Tea; Programming The Module - BRAVILOR BONAMAT RLX Operating Instructions Manual

1.4.2.4

Making tea

Using the glass jug or the airpot module, you can
also make tea. Making tea is done using the
same procedure as making coffee. However,
instead of paper coffee filters and coffee, use tea
or tea bags.
TIP
− When making tea, never use the filter pan, a
glass jug or airpot that has been used for
making coffee.
1.5

Programming the module

The operating panel is also used for programming
purposes.
During programming, the
lower certain values, and the ã−button to raise
them.
P1 (variable amount):
Setting the amount of hot water, with which the
coffee is made (0 – 98). Raising 2 will add
between 3 and 5 ml approximately to the
contents of the jug.
The value to be set depends on the contents of
the glass jug, the airpot, or the container.
P2 (maximum number of cups):
Setting the maximum number of cups (2 – 30)
that are to be prepared during a cycle.
P3 (Number of positions used):
Setting the number of cups prepared (2, 4, 6, 8,
etc.). These values increase by 2 cups at a time.
D mask = ã key
D show = 1
/ key
0
P4 (length of drip time):
Setting the time (1 – 20), which lies between the
point the water production is stopped, and the
indication the coffee making process is finished.
P5 (total):
Reading the total number of units produced (1
unit = approx. 1 litre).
ECopyright Bravilor Bonamat B.V.
Bravilor Bonamat BV
− To use loose tea, a special tea filter pan, with
− If you use teabags, you can use a normal
P1
1
/ −button serves to
0
P2
P3
P4
1. Simultaneously press the ã−button and the
2. Keep them pressed for about 10 seconds,
3. Let go of the buttons.
4. Adjust, if desired, the value.
5. Press both buttons once, or a couple of times
6. Wait for about 60 seconds.
sieve, is available.
filter pan. Place the tea bags in the filter pan,
or hang them in the jug.
Factory setting Set by you
Module
1 (1,7
): 24
litre
5 (2,0
): 18
litre
6 (1,9
): 10
litre
6
(2,2 ): 18
litre
Module
1
: 12
5 / 6
: 16
Module
1 :
2, 4, 6, 8,
10, 12
5 / 6: 2, 4, 6, 8,
10, 12, 14,
16
6 (= 60 sec.)
1
/ −button.
0
until P1 appears on the display.
− The value for P1 appears.
if necessary, for a short moment, to select the
next P values.
− The programming mode will automatically
be switched off, storing the set value.
3