Settings; General Programming Procedure; In General; Activating The Settings Program - BRAVILOR BONAMAT Blr10-002 Instruction Manual

1.6 Settings

The machine is equipped with a program
that allows you to set all the facilities of
the beverage maker. The program
comprises eleven components in the
following sequence:
1. § 1.8.1 Starting the rinsing program.
2. § 1.8.2 Blocking rinsing button.
3. § 1.8.3 Start descaling program.
4. § 1.9.1 Setting the quantity of
beverage per small cup.
5. § 1.9.2 Setting the quantity of
beverage per large cup.

1.7 General programming procedure

1.7.1 I
N GENERAL
Before you start programming, remember
which settings have to be changed.
Make a note of the settings you wish to
change. You can then enter all the
changes in one go, one after the other.
An explanation of the different setting
possibilities is given in § 1.8.1 trough
1.11.3.
1.7.2 A
CTIVATING THE SETTINGS PROGRAM
1. Open the door with the key (19).
2. Switch on the machine. Set switch (1)
to the 'on' position, which shows a red
indicator side at the switch.
3. Press the programming button (3) on
the inside of the door.
4. The number of small cups and large
cups dispensed appears in the
display (11) on the outside of the
door. See figure 4.
5. Attention! The program returns to
normal mode after 10 seconds. Press
again the programming button (3).
Fig. 4
6. § 1.10.1 Setting the strength of the
beverage per small cup.
7. § 1.10.2 Setting the strength of the
beverage per large cup.
8. § 1.10.3 Switching the mixer on or off
when tapping small cups.
9. § 1.11.1 Switching the mixer on or off
when tapping large cups.
10. § 1.11.2 Setting the water
temperature.
11. § 1.11.3 Setting descaling signal.
6. Press selection key
cleaning program will appear in the
display, see figure 5.
7. Press selection key
to proceed to the next possible
program/setting. In this manner you
can use the selection key
through all the settings in the
program. The display shows what can
be set after each step.
1.7.3 C
LOSING THE SETTINGS PROGRAM
1. If you have finished setting up the
program, press the programming
button (3) on the inside of the door
again. The new settings will now be
saved.
2. Check whether the changed settings
of points 3 to 10, § 1.6 are correct, by
tapping of a cup. If not, change the
settings so that they are correct.
(12). The
(12) again
to run
5