Crankshaft Pulley And Damper; Removal; Installation - Ford LRG-423 Service Manual

02-I 5
Engine Service, 2.3L 02-I 5
2.3L ENGINE SERVICE (Continued)
VALVE SEAL PROTECTOR
(PLASTIC INSTALLATION CA
SUPPLIED WITH VALVE SEA
W
,LS
VALVE
/ 6505 OR 6507
VALVE GUIDE
6510
A20946-B
2. Start valve stem seal carefully over cap. Push
valve stem seal down until jacket touches top of
valve guide.
3. Remove seal protector (plastic cap). Use Valve
Stem Seal Replacer T95T-651 O-B to install valve
stem seal on valve guide.
VALVE
VALVE
6505 OR 6507
7.
(0.28-O.
A209489B
4.
5.
6.
7.
8.
9.
IO.
11.
Apply a small amount of Ford Multi-Purpose
Grease DOA2-19584-AA, or equivalent, meeting
Ford specification ESR-M 1 Cl 59-A to valve
spring retainer key to hold in place during
installation.
With cylinder pressurized, place valve spring and
valve spring retainer into position.
Compress valve spring with Valve Spring
Compressor T95T-6565-A and install valve spring
retainer keys. Release spring to seat valve spring
retainer keys in proper cylinder.
Release air pressure and remove air adapter.
Install spark plug in proper cylinder.
Grease contact surfaces of roller finger follower
with Ford Multi-Purpose Grease DOAZ-19584-AA,
or equivalent, meeting Ford specification
ESR-Ml Cl 59-A.
Using Valve Spring Compressor T95T-6565-A,
compress and hold down the valve and spring.
Slide the roller finger follower into place over
valve and lash adjuster. Release spring.
Using Valve Spring Compressor T95T-6565-A,
compress and release lash adjuster.
Install valve cover as outlined in this section.
Crankshaft Pulley and Damper
Removal
1. Loosen crankshaft damper bolt.
2. Using flex handle, rotate drive belt tensioner
(6B209) and remove drive belt (8620).
3. Remove crankshaft damper from crankshaft
(6303).
Installation
1. . Align keyway with key, install crankshaft damper
on crankshaft, and snug crankshaft damper bolt.
2.
Position drive belt and rotate drive belt tensioner
away from drive belt.
3. Position drive belt under drive belt tensioner and
release drive belt tensioner, tensioning drive belt.
4. Tighten crankshaft damper retaining bolt to
127-165 Nom (93-121 lb-ft).