Transducer Setup - Standard Horizon FF520 Owner's Manual

Shallow Water
Depth Water
Fish Alarm
Temperature Upper
Temperature Lower
Temperature Rate
4.6

TRANSDUCER SETUP

This menu allows you to calibrate the speed through the water, water temperature and the
keel/prop offset of the transducer.
Keel Offset
Calibrate Water Speed
Calibrate Water Temp
Calibrate Aux Temp
Set Default
FF520
Figure 4.5 - Alarms sub-menu
: Triggers an alarm when depth becomes shallower than the value set.
: Triggers an alarm when depth becomes deeper than the value set.
: The options for Fish Alarm set the size of the fishes that, if detected by the unit, switches an
alarm to sound. These options are: Off, Small, Medium, Big and Huge. The alarm sounds if
the set size (or bigger) is detected.
: Triggers an alarm when the transducer reports a temperature above the value set.
: Triggers an alarm when the transducer reports a temperature below the value set.
: Triggers an alarm when the transducer reports a temperature variation rate above the value set.
Figure 4.6 - Transducer Setup sub-menu
: Allows you to offset the surface reading for the depth of a keel. This makes it possible
to measure depth from the surface, bottom of the boat or bottom of the propeller(s)
instead of from the transducer location.
: Allows calibrating the value of Water Speed coming from the transducer.
The calibration value, in the range between -10% to +10%, will be applied to the water
speed from the transducer
: Allows the calibration on the Water Temperature sensor. Using the readings from a
precise temperature measuring device, insert a positive/negative offset to display the
correct temperature.
: Allows the calibration of the Aux Temperature sensor. Using the readings from a precise
temperature measuring device, insert here a positive/negative offset to display right
value on FF screens.
: Restores the factory settings.
Page 29