Display Setup - Standard Horizon FF520 Owner's Manual

The Page Selection options are:
Auto : Selects automatically the 50kHz if depth is greather than 400ft and selects 200kHz if depth
is less than 300ft.
Full Display : Shows the full Fish Finder page allowing to select among the 200kHz Standard Fish Finder, 50
kHz Standard Fish Finder or 200/50 kHz Dual Fish Finder.
Chart/Fish : Shows the Chart page on the left half of the screen and the Fish Finder on the right half of the
screen. It is possible to select among the 200kHz Standard Fish Finder or 50 kHz Standard Fish
Finder.
Zoom Full page : Shows the zoomed Fish Finder on the left half of the screen and the unzoomed Fish Finder on the
right half of the screen. It is possible to select between the 200kHz Split Fish Finder or the 50 kHz
Split Fish Finder zoomed view.
4.2

DISPLAY SETUP

The Display Setup menu allows you to change the Fish Finder display page appearance.
The Display Setup options are:
Color Settings : Allows you to change the color of the Fish Finder display.
Scrolling Speed(*) : Adjusts the chart scrolling rate.
White Line : Controls how the STANDARD HORIZON GPS chartplotters displays information about the
bottom type (hard or soft). When the White Line is Off the bottom return will display as black (red).
When the White Line is On it can be used to determine bottom hardness.
Fish Symbols : Allows determining the graphical representation of underwater suspended targets. See below.
Off: shown as arches (echoes)
Icon: shown as Fish icons without the arches
Icon + Depth: shown as Fish icons and their relative depth values (shown accordingly to currently
Page 26
Figure 4.1 - Page Selection sub-menu
Figure 4.2 - Display Setup sub-menu
FF520