3.1.0a Customizing the Fish Finder menu selection
The default setting of the FISH FINDER selection in the Main Menu is 200kHz Full page,
however this may be changed to show images as shown in the Figure 3.1.0a.
To change:
1. Press [MENU].
2. Move the ShuttlePoint knob to highlight SETUP and press [ENTER] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight FISH FINDER SETUP and press [ENTER] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PAGE SELECTION and press [ENTER] or
move the ShuttlePoint knob to the right.
5. A page selection window will be shown. Move the ShuttlePoint knob to the right/left or
up/down to select the desired display and press [ENTER] to select.
6. Press [CLEAR] until the Main Menu is shown, move the ShuttlePoint knob to highlight
FISH FINDER and press [ENTER].
3.1.1
Soft Keys (CP175C and CP1000C)
1. From any page press one of the 5 Soft Keys located under the display which will show
the Soft Key selections.
2. Locate and press the Soft Key labeled 200kHz Full.
FF520
Figure 3.1.0 - Fish Finder page selection by [MENU]
Figure 3.1.0a - Page Selection menu
Page 19