STANDARD HORIZON offers is made from hard plastic which fits around the
transducer.
· To install the transducer and fairing block, the user measures the dead rise of the hull
and cuts the fairing block to that angle. One half of the fairing block mounts on the inside
while the other part of the fairing block mounts on the outside of the hull.
6.0.6
In-hull
This transducer is epoxyed to the inside of the hull that is not more than 1/2 inch thick and
is solid not cored.
6.1
OPTIONAL TRANSDUCERS ID SENSORS
FF520
Figure 6.1 - Optional Transducers
Page 35