Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT
This product is fitted with an OXYGEN DEPLETION SYSTEM which is an INTEGRAL PART
OF THE PILOT. You must maintain the correct pressure for the oxygen depletion system to
operate correctly (see data plate on page 4).
When checking gas pressure at the appliance ALL OTHER GAS APPLIANCES IN
PREMISES MUST BE OPERATING AT THE SAME TIME.
Failure to have correct pressure may result in unit cutting out intermittently.
TYPE OF INSTALLATIONS
TYPE 1. Magiglo Gas Log/Coal Set
TYPE 2. Magiglo Gas Log/Coal Set
LOCATION REQUIREMENTS FOR TYPE 1 & 2 INSTALLATIONS
1.
2.
3.
4.
5.
6.
7.
BURNER INSTALLATION
1.
2.
3.
4.
5.
Installed into masonry built fireplace intended to burn wood using the masonry chimney
to remove waste products.
Installed in conjunction with a prefabricated firebox into an existing fireplace using the
masonry chimney to remove waste products.
The fireplace must be built in accordance with the building regulations for masonry
chimneys.
The fireplace must be sufficiently deep enough to fully accommodate either the Gas
Log/Coal Set or a firebox fitted with a Gas Log/Coal Set in order that no fumes can escape
into the room. DO NOT ignore the depth of the lintel over the fireplace opening.
It is imperative that the chimney or flue operates correctly and also does not subject the
living area to spillage of combusted products. The flue or chimney should be tested and
proven to have an adequate updraught sufficient to remove all waste products of
combustion. (Refer to Commissioning Procedure).
Chimney dampers, baffles or restrictive plates must be removed or permanently fixed
open.
An AGA approved flue cowl with a minimum cross sectional area of the following shall be
fitted to every masonry chimney - 40,000sq mm (225mm dia).
If using a prefabricated firebox, the firebox must be sealed to the masonry or brickwork.
Permanent ventilation of the room where the fire is to be situated is essential while fire is in
operation. The room must have a minimum cross sectional area of 40,000sq mm of
effective ventilation.
Select the Magiglo series burner which best compliments your fireplace size.
Locate your gas fire into the rear of the fireplace or prefabricated fire box fixing to base or
grate by location lugs on burner.
It is preferable for the gas line to be brought into the rear of fireplace, therefore concealing
pipe work.
If installing the burner into an existing grate, remove that part of base of grate so that
controls are on underside of grate.
Connect gas line to burner connection using 1/2˝ flared copper union supplied.
5
Hide quick links:
Advertisement
Table of Contents
