LEDs
POWER
LNK/ACT
(TX)
LNK
(SX/LX)
FDX
1000
100
1000, 100
Installation
This chapter gives step-by-step installation instructions for the Converter.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not
be subjected to extreme temperatures, humidity, or electromagnetic
interference. Specifically, the site you select should meet the following
requirements:
-
The ambient temperature should be between 32 and 104 degrees
Fahrenheit (0 to 40 degrees Celsius).
-
The relative humidity should be less than 90 percent, non-condensing.
-
Surrounding electrical devices should not exceed the electromagnetic
field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength.
-
Make sure that the equipment receives adequate ventilation. Do not
block the ventilation holes on each side of the equipment.
-
The power outlet should be within 1.8 meters of the product.
User's Manual
Signamax
State
Indication
Steady
Power feeding in
Off
No power
Steady
A valid network connection established.
LNK stands for LINK.
Flashing
Transmitting and receiving data.
ACT stands for ACTIVITY
Off
Neither connection nor activity existing.
Steady
A valid network connection established.
LNK stands for LINK.
Flashing
Transmitting and receiving data.
ACT stands for ACTIVITY.
Off
Neither connection nor activity existing.
Steady
Connection in full duplex mode.
FDX stands for FULL DUPLEX.
Flashing
Collision occurred.
Off
Connection in half duplex mode
Steady
Connection at 1000Mbps speed.
Steady
Connection at 100Mbps speed.
Off
Connection at 10Mbps speed.
™
10/100/1000T/TX to 1000SX/LX
Gigabit Ethernet Media Converter
.
5