BMW R 1200 GS Manual page 106

7
104
Insert bulb holder 1 into
headlight housing.
Replacing brake light
and tail light bulbs
z
If it is not standing firm-
ly, the motorcycle could
topple in the course of the
operations described below.
Make sure that the motorcy-
cle is steady on its stand.
Make sure the ground is
level and firm and park the
motorcycle.
Switch off the ignition.
Remove screws 1.
Pull lamp housing 2 rear-
ward from retaining brack-
ets.
Press bulb 3 into its socket
and turn it counterclockwise
to remove.
Replace defective bulb.
Tail light/brake light bulb
standard designation
P25-2
Tail light/brake light bulb
voltage
12 V
Tail light/brake light bulb
wattage
5...21 W