DuraLabel LabPRO Quick Start Manual page 7

2. Place Ribbon Supply onto the empty Ribbon Supply Spindle and insert the
spindle into the Rear Hub.
3. Place the Ribbon Rewind Spindle, with the paper core, on the Front Hub.
Note: Make sure the flanges on the end of the ribbon spindles are on the
right side of the printer when viewing from the front. (See Figure 2)
Figure 2
New Ribbon Supply
Put on Rear Hub.
Empty Core
for used ribbon
Put on Front Hub.
Ribbon Spindle
4. Open the Printer Cover using the Printer Cover Release Levers.
(See Figure 1, pg. 4)
5. Thread the ribbon down and underneath the Ribbon Mechanism.
Note: The dull side of the ribbon should face down (face the label stock).
(See Figure 3)
6. Tape the entire width of the end of the ribbon to the front empty core.
7. Wind the ribbon onto the take-up core by rotating it with your thumb.
Figure 3
Used Ribbon
Ribbon goes
underneath
Print Head
Front of printer
Flanges on the Ribbon Spindles attaches
Dull side of ribbon face down
to right side of printer.
Rear Hub
Front Hub
New Ribbon Supply
Vinyl Tape
Back of printer
-  -