Bosch GCM 10 Operating Instructions Manual page 16

GCM10_ASIA.book Seite 8 Dienstag, 18. September 2007 9:40 09
Flexible Mounting
(see Figure )
D2
Clamp the electro tool with commercially available
screw clamps by the feet to the working surface.
Dust/Chip Extraction
Dust is generated while working that can be det
rimental to health, inflammable or explosive.
Suitable protective measure are required.
For example: Some types of dust are considered
to be carcinogenic. Use suitable dust vacuuming
and wear a dust protection mask.
Integrated Dust Extraction
(see Figure )
E
Press the clamp on the dust bag 27 together and slide
the dust bag over the sawdust ejector 34. The clamp
must engage in the groove on the sawdust ejector.
Release the clamp on the dust bag.
The dust bag must never come in contact with moving
parts of the machine while sawing.
Empty the dust bag in a timely manner.
External Dust Extraction
Use a suitable adapter from the Bosch accessory pro
gram to connect a vacuum cleaner to the sawdust
ejector 34. Firmly attach the adapter and vacuum
cleaner hose.
The vacuum cleaner must be suitable for the material
to be worked.
When vacuuming dry dust that is especially detrimen
tal to health or carcinogenic, use a special vacuum
cleaner.
Extending the Fence
(see Figure )
F
Before all work on the machine, pull the power
plug.
Ensure when extending or enlarging the
fence that the functionality of the electro
tool (especially of the swinging guard) is
not restricted.
For vertical bevel angle sawing, the fence must be re
positioned.
Loosen the clamping lever 30 and pull the fence exten
sion 22 completely out.
Reclamp with the clamping lever.
1 619 P04 359 • (2007.09)
Extending the Saw Table
Before all work on the machine, pull the power
plug.
Saw Table Extension
(see Figure )
G
Long work pieces must be supported at the free end.
Loosen the two socket head screws 18 with the Allen
key 21 (6 mm) provided.
Pull out the saw table extension 20 to the stop and
retighten the socket head screws.
Extension Hoop
(see Figure )
H
Slide the extension hoop 43 on either side of the elec
tro tool to the desired length into the holes 19 provid
ed for this purpose.
Use the stop 42 to saw off work pieces of equal
lengths.
Clamping the Work Piece
(see Figure )
I
Before all work on the machine, pull the power
plug.
To ensure optimum working safety, the work piece
must always be firmly clamped.
Do not work with work pieces that are too small to
clamp.
When clamping the work piece, do not
reach with the fingers under the clamping
lever of the quick action clamp.
Press the work piece firmly against the fence 6 and the
fence extension 22.
Insert the quick action clamp 7 provided into one of the
holes 17 intended for it. Adapt the quick action clamp
to the work piece by twisting the threaded rod 45.
Press the clamping lever 44 and thereby firmly clamp
the work piece.
Adjusting the Miter Angle
Before all work on the machine, pull the power
plug.
To ensure precise cuts, the basic adjustments of the
electro tool must be checked and adjusted as neces
sary after intensive use (see Section „Checking and
Adjusting Basic Adjustment").
English–8