20-Inch Rear Wheels And 6-Inch Front Casters - Invacare 9000 SL Service Manual

SECTION 5—SEAT TO FLOOR
Chart 31 - Seat-to-Floor Height of 17½ inches and 6° Angle
REAR WHEEL POSITION
OFFSET AXLE OPTION
FORWARD REARWARD
Hole 4
Hole 4
Hole 2

20-Inch Rear Wheels and 6-Inch Front Casters

If changing the seat-to-floor angle to 6°, anti-tippers MUST be installed.
Refer to the following table to determine the obtainable seat‐to‐floor heights and
seat‐to‐floor angles for 20‐inch rear wheels and 6‐inch front casters:
SEAT-TO-FLOOR
HEIGHT*
*NOTE: The seat‐to‐floor heights are based on urethane tires. If wheelchair is equipped with
pneumatic (properly inflated) or solid rubber tires, add ¼ inch to the measurements listed above.
These heights can vary +/‐ ¼ inch due to tire wear and manufacturing tolerances.
NOTE: Charts 32 to 39 apply to adult/hemi frame styles only. Refer to the charts for seat‐to‐floor
height settings for adult/tall (Adult/Tall Frame Style on page 31) and super low frame styles
(Super Low Frame Style on page 31) and Changing Seat‐to‐Floor Height on page 77 for recliner
frame styles.
9000 Series
STANDARD
N/A for this
frame style
Hole 2
WARNING
SEAT-TO-FLOOR
17½ inches
17½ inches
16½ inches
16½ inches
16½ inches
15½ inches
15½ inches
15½ inches
ANTI-TIP
PART/MODEL
MOUNTING
NUMBERS
N/A On-Chair
1113766
Off-Chair
REFER TO
ANGLE
3° Chart 32
6° Chart 33
0° Chart 34
3° Chart 35
6° Chart 36
0° Chart 37
3° Chart 38
6° Chart 39
48
FRONT CASTER
ADJC CAM
POSITION POSITION
Front
Notch
Part No. 1076155