SECTION 7—RECLINER
SEAT WIDTH
14-INCH
16-INCH
18-INCH
19-INCH
20-INCH
22-INCH
10. Secure the pivot link to the crossbraces and wheelchair frame with the four (4) button
screws and locknuts. Securely tighten.
11. Reinstall the two (2) button screws, locknuts and crossbrace saddle that secure the
bottom of the new crossbrace to the wheelchair frame. Repeat for opposite crossbrace.
Securely tighten.
NOTE: Position crossbrace saddle on wheelchair frame using the washer on the underside of the
wheelchair frame as a reference. See Detail ʺAʺ of FIGURE 7.10 for proper positioning of the
crossbrace saddle.
12. Install the new back and seat upholstery onto the wheelchair. Refer to Replacing the
Headrest/Back Upholstery and Replacing the Seat Upholstery in the ownerʹs manual,
part number 1056953.
NOTE: There are three (3) lengths of spreader bars‐one (1) for each of the following groupings:
14‐inch wide chairs, 16 to 19‐inch wide chairs, and 20, 22‐inch wide chairs. All spreader bars
install in the same manner.
13. Install the correct length spreader bar for the desired chair width. Refer to
Storing/Replacing the Spreader Bar in the ownerʹs manual, part number 1056953.
14. If applicable, reinstall the headrest upholstery. Refer to Replacing the Headrest/Back
Upholstery in the ownerʹs manual, part number 1056953.
15. If applicable, reinstall the headrest pillow. Refer to Replacing the Headrest Pillow in
the ownerʹs manual, part number 1056953.
9000 Series
PIVOT LINK
x
14-Inch
DO NOT use
16-Inch
18-Inch
x
DO NOT use
19-Inch
20-Inch
22-Inch
72
Part No. 1076155