Invacare 9000 SL Service Manual page 30

SECTION 5—SEAT TO FLOOR
Adult/Hemi
FIGURE 5.1 Changing Seat-to-Floor Height/Seat-to-Floor Angle
2. Refer to the following charts of rear wheel sizes and front caster sizes to determine
mounting adjustments for obtainable seat‐to‐floor heights/angles for the appropriate
frame style.
• Super Low Frame Style on page 31
• Adult/Tall Frame Style on page 31
• Adult/Hemi Frame Styles on page 32
• Changing Seat‐to‐Floor Height on page 77 for recliner frame styles
NOTE: If using amputee brackets, the following restrictions apply:
• Angle ‐ a 3° seat‐to‐floor angle is the only available angle.
• Rear Wheel Mounting Position ‐ Refer to the charts in the Owner's Manual, part number
1056953, for the proper rear wheel mounting position.
3. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 52.
4. If necessary, adjust the caster headtube position and/or the cam position. Refer to
Converting from Trailing to Leading or Leading to Trailing Casters on page 27 and/or
Repositioning/Replacing Cam on page 28.
5. If necessary, replace the forks. Refer to Installing/Replacing Six or Eight‐Inch Front
Casters and Forks in the Owner's Manual, part number 1056953.
6. If necessary, adjust the front caster position in the fork. Refer to Front Caster Mounting
Adjustments on page 26.
7. Reinstall the rear wheels onto the wheelchair. Refer to Removing/Installing Rear
Wheels on page 52.
9000 Series
Adult/Tall
DETAIL "A"
30
Super Low
Seat-to-Floor
Height
Recliner
Seat-to-Floor
Angle
Part No. 1076155