Invacare 9000 SL Service Manual page 62

SECTION 7—RECLINER
2. Align threads of threaded sector with exposed threads of locking rod through cutout
in recliner tube.
DO NOT route the cable assembly to the outside of the locking rod/recliner tube
assembly as it may rub against the tires.
3. Route cable assembly to the inside of the locking rod/recliner tube assembly.
4. Position U‐bolt in middle of support plate.
A 90° angle must be maintained to provide full contact of the threads between the
sector and the locking rod (Detail "A"). Otherwise, injury to the user and/or assis-
tant or damage to the equipment may result.
5. When connecting the lower cable assembly to the recliner tube, the housing must be
at 90° to the frame step tube.
DO NOT overtighten the locknuts on the U-bolt. Otherwise, damage to the
equipment may result.
6. Secure support housing/cable assembly and support plate to recliner tube with
existing U‐bolt and two (2) locknuts. Torque to 4 ft‐lbs. (48 inch‐pounds).
9000 Series
CAUTION
WARNING
CAUTION
62
Part No. 1076155