22-Inch Rear Wheels And 6-Inch Front Casters - Invacare 9000 SL Service Manual

Chart 20 - Seat-to-Floor Height of 17½ inches and 6° Angle
REAR WHEEL POSITION
OFFSET AXLE OPTION
FORWARD* REARWARD
Hole 4
Hole 4
Hole 3
*NOTE: This offset axle plate position requires the caster headtube to be leading to provide
adequate tire clearance between the rear tire and the front caster. Refer to Converting from Trailing
to Leading or Leading to Trailing Casters on page 27.

22-Inch Rear Wheels and 6-Inch Front Casters

If changing the seat-to-floor angle to 6°, anti-tippers MUST be installed.
Refer to the following table to determine the obtainable seat‐to‐floor heights and
seat‐to‐floor angles for 22‐inch rear wheels and 6‐inch front casters:
SEAT-TO-FLOOR
*NOTE: The seat‐to‐floor heights are based on urethane tires. If wheelchair is equipped with
pneumatic (properly inflated) or solid rubber tires, add ¼ inch to the measurements listed above.
These heights can vary +/‐ ¼ inch due to tire wear and manufacturing tolerances.
NOTE: Charts 21 to 28 apply to adult/hemi frame styles only. Refer to the charts for seat‐to‐floor
height settings for adult/tall (Adult/Tall Frame Style on page 31) and super low frame styles
(Super Low Frame Style on page 31) and Changing Seat‐to‐Floor Height on page 77 for recliner
frame styles.
Part No. 1076155
STANDARD
Hole 3
WARNING
SEAT-TO-FLOOR
HEIGHT*
17½ inches
17½ inches
17½ inches
16½ inches
16½ inches
16½ inches
15½ inches
15½ inches
SECTION 5—SEAT TO FLOOR
ANTI-TIP
PART/MODEL
MOUNTING
NUMBERS
N/A On-Chair
1113766
Off-Chair
REFER TO
ANGLE
0° Chart 21
3° Chart 22
6° Chart 23
0° Chart 24
3° Chart 25
6° Chart 26
0° Chart 27
3° Chart 28
43
FRONT CASTER
ADJC CAM
POSITION POSITION
Front
Notch
9000 Series