Invacare 9000 SL Service Manual page 47

*NOTE: The seat‐to‐floor heights are based on urethane tires. If wheelchair is equipped with
pneumatic (properly inflated) or solid rubber tires, add ¼ inch to the measurements listed above.
These heights can vary +/‐ ¼ inch due to tire wear and manufacturing tolerances.
NOTE: Charts 29 to 31 apply to adult/hemi frame styles only. Refer to the charts for seat‐to‐floor
height settings for adult/tall (Adult/Tall Frame Style on page 31) and super low frame styles
(Super Low Frame Style on page 31) and Changing Seat‐to‐Floor Height on page 77 for recliner
frame styles.
Chart 29 - Seat-to-Floor Height of 18½ inches and 6° Angle
REAR WHEEL POSITION
OFFSET AXLE OPTION
FORWARD REARWARD
Hole 1
Hole 1
Hole 3
Chart 30 - Seat-to-Floor Height of 17½ inches and 3° Angle
REAR WHEEL POSITION
OFFSET AXLE OPTION
FORWARD REARWARD
Hole 1
Hole 1
Hole 3
Part No. 1076155
STANDARD
Hole 3
STANDARD
Hole 3
SECTION 5—SEAT TO FLOOR
ANTI-TIP
PART/MODEL
MOUNTING
NUMBERS
POSITION
N/A On-Chair
1113766 Off-Chair
ANTI-TIP
PART/MODEL
MOUNTING
NUMBERS
POSITION
1360 On-Chair
1058836 Off-Chair
47
FRONT CASTER
ADJC CAM
POSITION
Front
Notch
FRONT CASTER
ADJC CAM
POSITION
Front
Notch
9000 Series