How To Test Your Alarm System; How To Test The Bell, Strobe And Internal Sounder - Honeywell Accenta User Manual

Accenta/Optima User Guide
2 = LED Keypad:
The LED keypad is limited to show the last eight set periods with the eighth being the oldest. Zone, Attack
(PA) and Tamper (TA) LED's will be on to show zone in alarm . Flashing LED indicates the first zone in
alarm. Day indicates the status of the panel at the time of the alarm.
• Press [PROG] and then enter your code [0][1][2][3]. The Day
LED goes off and the Tamper (TA) LED comes on to indicate that
you are in Programming mode.
• Press [CHIME] to enter into Event Log menu. LED's 1 and 2 are
on.
• Press [2] for LED keypad. The first zone to activate is indicated by a
flashing LED.
• Press [1 to 8] for the desired event or [CHIME] to go through
events in sequence.
• Press [RESET] twice to leave the menu.

How to Test Your Alarm system

You should check that your alarm system still works correctly by periodically carrying out the alarm system
tests described here.

How to Test the Bell, Strobe and Internal Sounder

This function tests the alarm function of the Bell, Strobe or Internal Sounder. Pressing the appropriate button
[1-3] toggles the function ON or OFF. Using the [up arrow] also selects the appropriate alarm function.
Pressing the [0] button turns all alarm outputs to OFF.
Pressing the [SET] button toggles the selected alarm output.
Pressing the [RESET] button turns off all outputs and leaves the function.
The outputs are:
1 = Bell, 2 = Strobe, 3 = Sounder
NOTE: To test the Low volume sounder enable option 3 only. To test for a high volume sounder enable both
options 2 and 3 together.
How to Test Alarm System
15
[PROG] then [0][1][2][3]
1 2 3 4 5 6 7 8
ower
Attack
Zones
Tamper
Day
[CHIME]
1 2 3 4 5 6 7 8
ower
Attack
Zones
Tamper
Day
[RESET]
1 2 3 4 5 6 7 8