How To Unset The System - Honeywell Accenta User Manual

Accenta/Optima User Guide

How to Unset the System

When you enter your premises you will need to unset (turn off) the system.
LCD Keypad:
• Enter the premises by the agreed entry route. Thesystem
produces an entry tone. The Power LED is on and the Day
LED is off indicating that the system is set.
• Enter your 4-digit code (0123 default).
• The system unsets with a double beep. The Day LED
comes on indicating that the system is unset.
• After 30 seconds the Day mode display appears.
LED Keypad:
• Enter the premises by the agreed entry route. Thesystem
produces an entry tone. The Power LED is on and the
Day LED is off indicating that the system is set.
• Enter your 4-digit code (0123 default).
• The system unsets with a double beep. The Day LED
comes on indicating that the system is unset.
If any Zone, TA (Tamper) or PA (Attack) LED's come on then an alarm has occurred, and an intrusion may
have taken place. Seek assistance before investigating further as intruders may still be on the premises. Then
reset the system.
When you enter your premises you will have a short period of time, usually 30 seconds, to enter your code. If
you fail to do this the system will go into alarm. Enter your code to stop the alarm.
How to Unset the System
S u n d a y S u n d a y S u n d a y S u n d a y S u n d a y
** SYSTEM UNSET ** ** SYSTEM UNSET ** ** SYSTEM UNSET ** ** SYSTEM UNSET ** ** SYSTEM UNSET **
S u n d a y S u n d a y
S u n d a y S u n d a y S u n d a y
3
0 1 - J a n 0 1 - J a n 0 1 - J a n 0 1 - J a n 0 1 - J a n
14:10 14:10 14:10
14:10 14:10
[4-digit code]
0 1 - J a n 0 1 - J a n
0 1 - J a n 0 1 - J a n 0 1 - J a n
14:10 14:10 14:10 14:10 14:10
Day Power
TA PA
[4-digit code]
Day Power
TA
PA