How To Test Your Alarm System; How To Test The Bell, Strobe And Internal Sounder - Honeywell Accenta User Manual

How to Test Alarm System
2 = LED Keypad:
The LED keypad is limited to show the last eight set periods with the eighth being the oldest. Zone,
LEDs are on, to show zone in alarm . A flashing LED indicates the first zone in alarm. indicates the
status of the panel at the time of the alarm.
• Press and then enter your code [0][1][2][3]. The LED goes
off and the LED comes on to indicate that you are in
Programming mode.
• Press to enter into Event Log menu. LED's 1 and 2 are on.
• Press [2] for LED keypad. The first zone to activate is indicated by a
flashing LED.
• Press [1 to 8] for the desired event or
in sequence.
• Press twice to leave the menu.

How to Test Your Alarm system

You should check that your alarm system still works correctly by periodically carrying out the alarm system
tests described here.

How to Test the Bell, Strobe and Internal Sounder

This function tests the alarm function of the Bell, Strobe or Internal Sounder. Pressing the appropriate key.
[1-3] toggle the function ON or OFF. Using the
Pressing [0] turns all alarm outputs to OFF.
Pressing toggles the selected alarm output.
Pressing turns off all outputs and leaves the function.
The outputs are:
1 = Bell, 2 = Strobe, 3 = Sounder
NOTE: To test the Low volume sounder enable option 3 only. To test for a high volume sounder enable both
options 2 and 3 together.
Accenta/Optima User Guide
to go through events
also selects the appropriate alarm function.
16
and
then [0][1][2][3]
1 2 3 4 5 6 7 8
Zones
1 2 3 4 5 6 7 8
Zones
4 8
1 2 3 5 6 7